Snail Castings

Step 1

Mold

Set out the mold for casting.

Secure the two parts of the mold together with a rubber band.

Place the mold upright inside a tray.

Step 2

Prepare the Li-Qua-Ché

Thin down the liquid maché using 1 part water to 2 parts mache’ in a mixing bowl or cup.

Mix well.

Step 3

Casting

Pour the liquid maché into the plaster mold filling it to the top.

Gently shake the mold back and forth to release any trapped air bubbles in the liquid.

Allow the liquid maché to settle in the mold.
*Additional liquid maché may be added if needed.

Step 4

Set Up

Allow the liquid maché to set up. Once a 1/4” wall is formed on the perimeter of the mold pour the excess liquid maché back into its original container.

Step 5

Dry

Allow the liquid maché to dry.
Drying time will vary dependent upon room temperature.
As the liquid maché dries it will pull away from the sides of the mold.

Step 6

Casting Removal

Remove the rubber band from the plaster mold.

Gently separate the two parts of the plaster mold.

Remove the snail casting from the plaster mold.

Step 7

Base

Cut away the excess maché from the bottom of the snail casting with a knife.

Step 8

Seam

Scrape away the casting seam using a cleanup tool.

Step 9

Paint

Paint the snail casting.